Cadac F-Type Instrukcja Użytkownika Pobierz pdf (Strona 36)

2-8 Central Control Module 7896

F-Type Revision F2005-2

516 ,QWHUQDO#PRGXOH#VHWWLQJV

51614 0RGXOH#SRZHU0XS#VWDWH#+,VR21LVR#VHOHFWLRQ,

When the console is first powered up, programmable modules may be set to power

up in ISOLATE mode or in NOT ISOLATE mode. This option is user selectable by

setting links on the motherboard. The factory setting is NOT ISOLATE.

51615 6HOHFWLQJ#RU#FKDQJLQJ#WKH#RSWLRQV

Place the CCM module on a flat surface so that the front panel is facing you and the

mother board is laying on the surface. Locate the three way male molex connector

CN29

. This can be found on the mother board near the MIDI B LED25, close to the

front panel.

The factory setting is NOT ISOLATE, so that the

programmable jumper

is set to link

pins 2 and 3.

To change the POWER-UP STATE to ISOLATE:

Pull off the

programmable jumper

and replace it so that pins 1 and 2 are linked.

517 0 RGXOH#OHYHO#VRIWZ DUH

When first switched on or after being reset, the CCM display briefly shows the soft-

ware version number and then executes a check of its internal memory.

Assuming all is found to be well, the display then changes to “cadac F-Type” and the

CCM is ready to be used. This is one of the “root” displays, and it is always possible

to get back to this point by pressing the

[Esc]

key (it may be necessary to press

[Esc]

several times). The other “root” display possibilities are a

cue number

or a

memory number

. If this is the case, the appropriate keypad buttons will illuminate to

show which will perform a useful function if pressed at this point.

The basic operations that can be performed from the “root” display can be summa-

rized as follows, where button names are shown in

bold

type:-

Operation:Type:

Recall cue at the EDIT pointer on PC

Rcl

Save cue to CURRENT EDIT pointer on PC

Sve

Recall cue number nnn.n from PC

nnn.n

Rcl

Save cue number nnn.n to PC

nnn.n Sve

Recall internal memory n

Mem n Rcl

10 7 normally CLOSED contact

23 7 MOVING contact (wiper)

11 7 normally OPEN contact

24 8 normally CLOSED contact

12 8 MOVING contact (wiper)

25 8 normally OPEN contact

13 GROUND

Pin no. Relay no. Function

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 107 108

Komentarze do niniejszej Instrukcji

Brak uwag

Cadac F-Type Instrukcja Użytkownika Strona 36

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Panel sterowania Cadac F-Type