Cadac R-Type Instrukcja Użytkownika Pobierz pdf (Strona 57)

Mono Input Channel 8241 7-3

Revision R2005-2 R-Type

selected PFLs/Listens to be cancelled, unless PFL hold has been selected or

another PFL/Listen button is still pressed. See 6.3 Fader Control Module (FCM) 1 - 4

and 12.1.8 PFL - select through to 12.1.22 Headphones - MUTE.

:1416 /LQH0XS#WRQH

Press this button to apply a Line-up tone to the input. The frequency and level of the

line up tone applied is controlled from the OSC/Comms module 8271, see 11.1 Osc

& Communications 8271 - front panel. Pressing this button will also disable the 48v

phantom power if selected, see 6.1.4.

:1417 7;9#3KDQWRP#SRZHU

Press this button to switch on the 48V Phantom power to any connected microphone.

Notice that the 48 v phantom power is disabled on this channel if the line-up tone is

selected (see 6.1.3).

:1418 053G%#3DG

Press this button to apply -20dB attenuation to the input signal to the microphone

amplifier. If the gain potentiometer (see 7.1.1 Input Gain) is set for 20dB and the pad

applied, this allows for the use of line level (0dB nominal) devices instead of having a

separate line input.

:1419 3KDVH#UHYHUVH

Press this button to reverse the phase of the signal coming into the module.

:141: 'LUHFW#2XW SXW#OHY HO

Use this rotary control to adjust the Direct Output level. This control has 6dB in hand

with a 0dB centre detent position.

:141; 'LUHFW#2XW SXW#6HOHFW

The direct o/p send is normally fed from post fader. Press PRE will take the signal

from pre-fader but post INS/EQ. Pressing MIC will override the PRE button (the PRE

LED will go out) taking the d/o directly from the o/p of the MIC amp. In this condition

the Highpass filter is still available if needed.

:141< 2XWSXW#WR#0DWUL[

These buttons are used to select direct routing to matrix busses 13 to 16 from POST

fader, with or without stereo panning. See 7.1.32 Matrix 13 - 16 and 7.1.27 PAN Con-

trol.

:14143 6HQGV#<$2%#0#49$2%

Sends 9A/B - 16A/B are dedicated mono sends, each with its own level control. Each

pair has its own PRE/POST FADER and ON/OFF switch.

Sends 9A/B - 12A/B and 13A/B - 16A/B can be selected to follow the STEREO PAN-

NING by using the buttons in the panning section at the bottom of this module. See

7.1.27 PAN Control, 7.1.29 Stereo PAN to groups 9 - 12 and 7.1.32 Matrix 13 - 16.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 138 139

Brak uwag

Cadac R-Type Instrukcja Użytkownika Strona 57